An ITTF table tennis table is 2.74 m (9 ft) long, 1.525 m (5 ft) wide, and its playing surface stands 76 cm (2 ft 6 in) above the floor. It is the smallest surface this atlas measures. The net is 15.25 cm (6 in) high along its whole length, with no lower height at the center the way a tennis net has, and its posts stand 15.25 cm outside each side line. What most guides leave out is the room around the table: the ITTF’s Regulations for International Competitions set a minimum playing space of 14 m long, 7 m wide and 5 m high for sanctioned competition. That is roughly five times the table’s own length. The figures on this page come from the ITTF Statutes, each labeled as a rule or as something this page had to derive from one.
Dimensions and layouts
ITTF Rule 2.1.1 fixes the table at 2.74 m long and 1.525 m wide, its playing surface lying in a horizontal plane 76 cm above the floor. Side lines and end lines are painted 2 cm wide along the table’s outer edges, and in doubles a 3 mm center line splits each half of the table into two service courts, counted as part of the right-hand court. None of this changes by level of play: the table a club buys is the same table the ITTF uses for a World Championship.
The playing space is a separate rule, in a separate chapter. Rule 3.2.3.1 sets a minimum cuboid of 14 m by 7 m by 5 m high around the table for ITTF-sanctioned competition, reduced to 8 m by 6 m for wheelchair events and 10 m by 5 m for Masters events. The rule states no reduced height for either. The full table, with the net’s dimensions and the exact wording of each rule, is in the table tennis table dimensions, markings and layout guide.
Equipment
The net assembly is the table’s one piece of standing equipment: a net 15.25 cm high, suspended from posts of the same height, extending 15.25 cm beyond each side line for a post-to-post length of 1.83 m. The ITTF Statutes do not print that figure directly; it follows from the table width and the post offset. A regulation ball is 40 mm across and weighs 2.7 g. The playing surface itself must yield a bounce of about 23 cm when the ball is dropped on it from 30 cm, which is as much a property of the table as of the ball.
Overhead plan
The same surface seen from straight above, drawn to scale. Nothing is foreshortened here, so every figure can be read off the drawing the way a tape measure would take it.
Detail sheet
A rule book fixes more than the shape of the surface, and the rest of it is too small to draw at court scale: a mark a few centimeters long, a post standing a meter off the sideline, the clearance around the whole thing. Each one here has its own frame and its own scale.
Official sources
One governing body is cited on this page. The International Table Tennis Federation publishes its Laws of Table Tennis and its Regulations for International Competitions together, inside the ITTF Statutes.
- International Table Tennis Federation, ITTF Statutes 2026, Chapter 2 (The Laws of Table Tennis, Rules 2.1 and 2.2) and Chapter 3 (Regulations for International Competitions, Rule 3.2.3).
These figures were checked against that document on 10 September 2026. How each one is dated and marked as a rule or a derivation is set out on the methodology page. If a number here looks wrong, report it through corrections.
Explore the playing surface
Table Tennis court guides and tools
Use the verified guides below for dimensions, markings, planning details, and the history behind the playing surface.
Dimensions
Table Tennis Table Dimensions, Markings and Layout
Official table tennis table dimensions: 2.74 by 1.525 meters at 76 cm high, the net's height and extension, and the ITTF's 14 by 7…
Open guide